Table of Contents
Advertisement
362
5-6. Using the other interior features
3
Press and hold the desired Home-
®
Link
button (inside the vehicle)
for 2 seconds and release it. Repeat
this sequence (press/hold/release)
up to 3 times to complete pro-
gramming.
If the garage door opener motor
operates when the HomeLink
button is pressed, the garage door
opener motor recognizes the
®
HomeLink
Enabling 2-way communication
■
with a garage door (only available
for compatible devices)
When enabled, 2-way communication
allows you to check the status of the
opening and closing of a garage door
through indicators in your vehicle.
2-way communication is only available
if the garage door opener motor used
is a compatible device. (To check
device compatibility, refer to
www.homelink.com.)
1
Within 5 seconds after program-
ming the garage door opener has
been completed, if the garage door
opener motor is trained to Home-
®
Link
, both garage door operation
indicators will flash rapidly (green)
and the light on the garage door
LS500h_OM_OM50F42U_(U)
®
signal.
opener motor will blink twice, indi-
cating that 2-way communication is
enabled.
If the indicators do not flash, perform
3
within the first 10 presses of the Home-
®
Link
button after programming has been
completed.
2
Press a programmed HomeLink
button to operate a garage door.
3
Within 1 minute of pressing the
®
HomeLink
button, after the
garage door operation has
stopped, press the "Learn" or
"Smart" button on the garage door
opener motor. Within 5 seconds of
the establishment of 2-way com-
munication with the garage door
opener, both garage door opera-
tion indicators in the vehicle will
flash rapidly (green) and the light
on the garage door opener motor
will blink twice, indicating that
2-way communication is enabled.
Reprogramming a single Home-
■
®
Link
button
When the following procedure is per-
formed, buttons which already have
devices registered to them can be
overwritten:
1
With one hand, press and hold the
®
desired HomeLink
2
When the HomeLink
starts flashing (orange), continue to
®
hold the HomeLink
perform "Programming Home-
®
Link
"
1
(it takes 20 seconds for
2
and
®
button.
®
indicator
button and
Advertisement
Table of Contents
