Table of Contents
Advertisement
284
4-5. Using the driving support systems
Hybrid system output restriction control begins operating
D
System determines that possibility of collision with detected object is high
E
Hybrid system output reduced
F
System determines that possibility of collision with detected object is extremely
G
high
Brake control begins operating
H
Brake control strength increased
I
Example: Multi-infomation display:
J
"BRAKE!"
Example: Multi-infomation display: "Switch to Brake"
K
■
If the Parking Support Brake has oper-
ated
If the vehicle is stopped due to operation of
the Parking Support Brake, the Parking
Support Brake will be disabled and the
PKSB OFF indicator will illuminate. If the
Parking Support Brake operates unneces-
sarily, brake control can be canceled by
depressing the brake pedal or waiting for
approximately 2 seconds for it to automati-
cally be canceled. Then, the vehicle can be
operated by depressing the accelerator
pedal.
Re-enabling the Parking Support Brake
■
To re-enable the Parking Support Brake
when it is disabled due to operation of the
Parking Support Brake, either enable the
system again (→P.281), or turn the power
switch off and then back to ON mode.
Additionally, if the object becomes no lon-
ger in the traveling direction of the vehicle
or if the traveling direction of the vehicle
changes (such as changing from moving
forward to backing up, or from backing up
to moving forward), the system will be
re-enabled automatically.
If "Parking Support Brake Unavailable"
■
is displayed on the multi-information
display and the PKSB OFF indicator is
flashing
If the vehicle is stopped due to operation of
the Parking Support Brake, the Parking
Support Brake will be disabled and the
PKSB OFF indicator will illuminate.
LS500h_OM_OM50F42U_(U)
●
A sensor may be covered with ice, snow,
dirt, etc. Remove the ice, snow, dirt, etc.,
from the sensor to return the system to
normal.
Also, due to ice forming on a sensor at
low temperatures, a warning message
may be displayed or the sensor may not
be able to detect an object. Once the ice
melts, the system will return to normal.
If this message is displayed only when the
●
R shift position is selected, the rear cam-
era lens may be dirty. Clean the camera
lens. If this message is displayed in any
forward shift position , a sensor on the
front or rear bumper may be dirty. Clean
the sensors and their surrounding area
on the bumpers.
If this message continues to be displayed
●
even after cleaning the sensor, or is dis-
played even though the sensor is clean,
have the vehicle inspected by your Lexus
dealer.
●
Initialization may not have been per-
formed after a 12-volt battery terminal
was disconnected and reconnected. Ini-
tialize the system. (→P.284)
If this message continues to be displayed
even after initialization, have the vehicle
inspected by your Lexus dealer.
If a 12-volt battery terminal has been
■
disconnected and reconnected
The system needs to be initialized. To initial-
ize the system, drive the vehicle straight
ahead for 5 seconds or more at a speed of
approximately 22 mph (35 km/h) or more.
Advertisement
Table of Contents
