Table of Contents
Advertisement
Programming an entry gate (for
U.S.A. owners)/Programming a
device in the Canadian market
Press and release the remote control
transmitter button at 2 second inter-
vals, repeatedly, until the HomeLink
indicator light changes from slowly
flashing (orange) to rapidly flashing
(green) (rolling code) or continuously
lit (green) (fixed code).
4
Test the HomeLink
pressing the newly programmed
button and observing the indicator
light:
Indicator light illuminates: Program-
ming of a fixed code device has
completed. The garage door or
other device should operate when a
®
HomeLink
released.
Indicator light flashes rapidly: The
garage door opener motor or other
device is equipped with a rolling
code. To complete programming,
firmly press and hold the Home-
®
Link
button for 2 seconds then
release it.
If the garage door or other device
does not operate, proceed to "Pro-
LS500h_OM_OM50F42U_(U)
5-6. Using the other interior features
®
®
operation by
button is pressed and
gramming a rolling code system".
5
Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
2 or more people may be necessary to
complete rolling code programming.
1
Locate the "Learn" or "Smart" but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner's
manual supplied with the garage door
opener motor for details.
2
Press and release the "Learn" or
"Smart" button.
3
Perform
within 30 seconds after per-
forming 2.
361
®
buttons.
5
Advertisement
Table of Contents
