Fluke Norma 4000 User Manual page 100

Remote Control
Users Guide
Input
Channel Suffix
INPut21 (torque)
INPut25 (speed)
INPut22 (torque)
INPut26 (speed)
INPut23 (torque)
INPut27 (speed)
INPut24 (torque)
INPut28 (speed)
Command
:INPut[21..28]
:TYPe
INPut[21..28]:TYPe VOLTage | FREQuency
Description
Selects the type of signal measured for a Process Interface input.
Parameter(s)
VOLTage
FREQuency
*RST state
FREQuency for all Process Interface inputs
Example(s)
INP21:TYP VOLT
INP25:TYP?
Invalidates
-
Invalidated by
-
The SENSe2 node distinguishes the mechanical from the electrical system (SENSe1 for
the electrical system is the default node of the root level of the command tree). The
SENSe2:xxx:VOLTage nodes apply if the corresponding input type is set to
INPutx:TYPe VOLTage and SENSe2:xxx:FREQuency nodes apply if the corresponding
input type is set to INPutx:TYPe FREQuency respectively.
4-52
Drive
Index
1 SENSe2:TORQue|SPEed|POLepairs|TYPe|REFerence1[:POWer]
2 SENSe2:TORQue|SPEed|POLepairs|TYPe|REFerence2[:POWer]
3 SENSe2:TORQue|SPEed|POLepairs|TYPe|REFerence3[:POWer]
4 SENSe2:TORQue|SPEed|POLepairs|TYPe|REFerence4[:POWer]
Parameter
VOLTage | FREQuency
Input signal is voltage.
Input signal is frequency.
Response: FREQ
Sense Subsystem Phase Suffix
Default
Value/Unit
FREQuency Analog/digital sensor
Remark