Start And Stop Procedures And Basic Operation; Start And Stop Procedures - Omron BU100RS Instruction Manual

3-3 Start and stop procedures and basic operation

3-3-1 Start and stop procedures

For cautions when operating the UPS, including start and stop, refer to "Caution (for use)"
shown in the "Safety precautions" of the beginning of this manual.
■ Start procedure
Turn on the "Power" switch of the UPS.
・ Output begins in Inverter Operation a few seconds after the switch is activated.
(Status indicator "
・ The status indicator displays "
Battery Mode for about 10 seconds. (If the battery voltage is low, the
self-diagnostic test is not performed. It is automatically executed after the battery
is charged.) When the self-diagnostic test finishes successfully, switching to AC
output from commercial power is performed and normal operation starts.
・ When the self-diagnosis test finishes normally, the unit enters the normal
operating state through inverter operation.
・ When the self-diagnostic test is not performed, AC output begins immediately
inverter operation.
・ During operation, the battery is charged automatically.
AC input
Status indicator
Power supply SW
Power supply
output LED
Commercial
Operating mode
Power Battery
Commercial
Output
Power Battery
BU100RS
")
Status indicator
Beep
Power supply output receptacles
ON
OFF
D-1
ON
OFF
ON
OFF
preparation
1 sec.
<Note>
D-1: Display the latest UPS fault mode
(If there is no record for UPS fault, UPS display the
3 Check and start operation
3-3 Start and stop procedures and basic operation
", and the self-diagnostic test is performed in
None
Outputs power (connected devices are powered)
Startup Bypass Self-diagnostic
operation
a few a few
seconds seconds
Inverter
test operation
about
15 sec.
3
47