4.
Ensure that the screws are tightened.
As shown in the figure below, check that there is no gap between the rack and each ear
bracket.
If a gap exists, as in step 3, while lifting the rear side, make the UPS level and tighten
the screws again to eliminate the gap.
* Proceed to step 5 if there has been no problem so far.
<Vertical installation>
Reference
This section explains how to mount the UPS into a rack for vertical installation.
For details about horizontal installation, refer to pages 25 to 27.
* If the rack's posts have no female threads, attach rack cage nuts in advance.
BU100RS
Correct installation
No gap
2 Installation and connection
2-1 Installation
Incorrect installation
Gap
2
27