Connecting A Device To A Terminal Block - Omron BU100RS Instruction Manual

2-2-2 Connecting a device to a terminal block

Connect only devices with rated voltage 100-120 VAC.
● The rated output voltage of the product is 100-120 VAC.
● Overvoltage may damage a connected device.
For other cautions when connecting the UPS, refer to "Caution (for installation and
connection)" shown in the "Safety precautions" of the beginning of this manual.
Caution
For wiring, ensure that the output wiring capacity satisfies the
specifications for the load devices.
Make sure to properly match the AC output terminal. Connect to the AC
output terminal of the product with the AC input being cut off and the
power supply switch being turned "OFF". Be sure to attach the terminal
block cover.
● Failure to do so may result in electric shock or ground fault.
● Do not connect to the input side of the AC terminal block because connection has
already been made there.
Insert an emergency stop switch or externally-installed breaker between
the load devices and the product, and arrange it where it is easy to
operate.
■ Connection procedure
1.
Loosen the clamp on the side of the AC input cable, then remove the screws for the
terminal block cover and detach the terminal block cover.
BU100RS
Caution
(for connection)
(for installation and connection)
2 Installation and connection
2-2 Connecting the equipment
2
33