Table of Contents
Advertisement
2 Installation and connection
2-2 Connecting the equipment
2.
Run the wires through the terminal block cover (with cable clamp) after removing the
cap of cable clamp for AC output side.
3.
Connect the L line to L. Connect the N line to N, and connect the G line to G.
Connections to the terminal block shall comply with the standards in Table 1.
(Input surge protection GND)
Table 1
34
Output
AC output
Connectable wire type
Connectable wire size (copper wire only)
Recommended cable size
L, N, G
Amount of stripped wire
Tightening torque
Outer diameter of the calbe
Recommended ring terminal for the wire
Already connected to
AC input terminal block
AC input
G N L G N L
Output terminal
1.25～4mm
Input terminal
(mounted by default)
Flexible cord
2
（AWG16～AWG12）
2 mm
(AWG14)
2
6 to 8 mm
1.23±0.15 N・m
φ 6 to 10mm
V2-P4 (JST)
BU100RS
Advertisement
Table of Contents
