Quick Setup - Runco Video Xtreme VX-2000d Operating Manual

Table 3-1 gives a quick overview of the VX-2000d installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
Connect the DHD Controller to the projector
2
Connect signal sources to the DHD Controller
3
Connect external controller to RS-232 port (optional)
4
Connect other home theater components to 12-volt trigger
5
outputs (optional)
Apply power to the projector
6
For rear-screen and/or ceiling-mount installations, select
7
the proper picture orientation
Primary lens adjustments: projected image size (zoom),
8
position (shift) and focus
Install CineWide anamorphic lens (optional)
9
CineWide lens adjustments: position, pitch (angle),
10
geometry and focus
Projector calibration – Analog 1080i and
lower-resolution signals:
Adjust the following for Component SD input; save settings
when finished:
• Aspect ratio
11
• Brightness
• Contrast
• Color level
• Tint
• Input position
Repeat Step 11 for S-Video 1, S-Video 2, Composite
12
Video, HD1 and HD2 inputs
Projector Calibration – Digital 1080i or 1080p signals:
Adjust the following for HDMI 1 and HDMI 2 inputs:
• Brightness
• Contrast
13
• Color level
• Tint
• Input position
Runco VX-2000d Owner's Operating Manual
Procedure
For Details, Refer to
page...
20
25
26
30
30
32
32
22, 33
34
35
39 through 52
52 through 61
19
Installation
3.2

Quick Setup