Hd/Rgb Adj; Options - Runco Video Xtreme VX-2000d Operating Manual

Select HD/RGB Adj. from the Main Menu to view input signal resolution and timing
information. To do this, select Signal Info from the HD/RGB Adj. menu.
Signal Info: Select Signal Info from the HD/RGB Adj. menu to display the resolution,
horizontal frequency and vertical frequency of the input current signal.
Select Options from the Main Menu to perform the following projector configuration tasks.
Image Shift: Select Image Shift from the Options menu to vertically shift the projected
image.
Subtitle: Select Subtitle from the Options menu to adjust the projected image height in
small increments.
Image Shift and Subtitle can only be adjusted for certain 1080i
Note
signals.
Overscan: Refer to Overscan on page 46.
Default: To reset the Overscan setting to its default value, select Default from the Options
menu, then select Yes to confirm the reset.
LED: Select LED from the Options menu to change the behavior of the projector's
indicator LEDs.
• When set to ON, the LEDs indicate operating status as described in VX-2000d at a
Glance on page 5.
When you set the Auto Power Off function (refer to Power Save,
Note
below) to Off, the LED function is automatically set to On.
• When set to OFF, the LEDs illuminate when the VX-2000d is in standby mode, warming
up or indicating an error condition; otherwise, they are off.
Lamp Hours (read-only): Refer to Lamp Hours on page 50.
OSD: When you select an aspect ratio or input with the remote control (or from the DHD
Controller), the VX-2000d displays your selection on-screen. To prevent the display of
these items, select OSD from the Options menu and set it to Off.
Signal Type: Select Signal Type from the Options menu to specify the incoming signal
type (encoding method):
• Choose Auto to have the VX-2000d automatically detect the signal type.
• Choose RGB (1) for RGB-encoded video signals.
Runco VX-2000d Owner's Operating Manual 59
Operation

HD/RGB Adj.

HD/RGB Adj.
Frequency 0
Phase 0
H-Shift 0
V-Shift 0
Default
Special Modes
Signal info
Auto Setup

Options

Options
Image Shift
Subtitle
Overscan +
Overscan
Default
Adjust White Level
Adjust Black Level
LED
Lamp Hours
OSD
Signal Type
Color Space Auto
HDMI Black Level
Background
Power Save
Baud Rate 9600 bps
Fan Mode
Orientation
Factory Default
0
0
- 5%
30
0
0
On
On
3
0
2
FF