Connecting An External Ir Receiver To The Dhd Controller; External Ir Receiver Connection - Runco Video Xtreme VX-2000d Operating Manual

Projector: The projector is equipped with an additional 12-volt trigger output. This trigger
activates when the projector is turned on. Connect it to your retractable screen or other,
12-volt trigger-activated equipment as shown in Figure 3-13.
HDMI
HDMI
50-60Hz 100-240V IN AC
AC IN 100-240V 50-60Hz
to retractable screen
or other, 12-volt
trigger-activated
equipment
Figure 3-13. 12-volt Trigger Output Connection (from Projector)
If infrared signals from the remote control cannot reach the DHD Controller due to
excessive distance or obstructions such as walls or cabinet doors, you can connect an
external IR receiver to the DHD Controller to extend the range of the remote control. See
Figure 3-14.
IR Receiver
Remote
Control
Figure 3-14. External IR Receiver Connection
When an external IR receiver is connected to the wired IR input, the
Note
built-in IR sensor on the DHD Controller is disabled.
Runco VX-2000d Owner's Operating Manual
RETURN ENTER DOWN
RETURN ENTER DOWN
(cylindrical,
DC power
supply-type
plug)
Sleeve = Ground
Tip = +12V
SYSTEM CONTROL INTERFACE
RISK OF ELECTRIC SHOCK
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
TRIGGERS
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
IR
1 2 3
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
S-Video 1
100-230VAC 50-60 Hz, 165 Watts Max
Video S-Video 2 RS-232 Out RS-232 Control
Ring = +5V
Tip = IR Input
Sleeve = Ground
(3.5-mm
mini phono
plug)
RATIO
UP LEFT RIGHT MENU ASPECT STANDBY ON
UP LEFT RIGHT MENU ASPECT STANDBY ON
RATIO
TRIGGER IR OUT RS-232
TRIGGER IR RS-232 OUT
CAUTION
!
DO NOT OPEN
Made In USA
31
Installation
Connecting an External IR
Receiver to the DHD
Controller