Table of Contents
Advertisement
Chapter 2 Using the XV-3080 Effects
Control 1–4 (MFX Control 1–4 Source)
OFF: No controller is used.
CC01–95: Controller numbers 1–95 (except for 32)
BENDER: Pitch Bend
AFTERTOUCH: Aftertouch
SYS-CTRL 1–4: System control (Control 1–4)
Destination
This selects the Multi-Effects parameter to be controlled
using the MFX Control 1–4 source.
Sens (MFX Control Sens) -63– +63
If you wish to modify the selected parameter in a positive (+)
direction – i.e., a higher value, toward the right, or faster etc.
– from its current setting, select a positive (+) value. If you
wish to modify the selected parameter in a negative (-)
direction – i.e., a lower value, toward the left, or slower etc. –
from its current setting, select a negative (-) value. Higher
numbers produce a greater amount of change.
RHYTHM MFX OUT (Rhythm MFX
Output)
Output (Output Assign) A/B/C
This setting specifies the stereo pair of OUTPUT jacks to
which the stereo output of the Multi-Effects unit is routed.
Dry (Dry Output Level) 0–127
This sets the Multi-Effects unit's output level to the selected
jacks.
Chorus (Chorus Send Level) 0–127
This sets the amount of the Multi-Effect unit's output to be
sent to the Chorus.
Reverb (Reverb Send Level) 0–127
This sets the amount of the Multi-Effect unit's output to be
sent to the Reverb.
32
Making Chorus Settings
The XV-3080's Chorus effect unit can also be used as a stereo
delay unit.
These settings allow you to select chorus or delay, the
characteristics of the selected effect type, and the Chorus
output routing.
RHYTHM CHO TYPE (Rhythm Chorus
Type)
This selects either Chorus or Delay.
Type
OFF: Neither Chorus or Delay is used.
CHORUS: Chorus is used.
DELAY: Delay is used.
RHYTHM CHO PRM (Rhythm Chorus
Parameter)
For Chorus
Rate (Chorus Rate) 0.05–10.00 Hz
This specifies the modulation frequency of the chorus effect.
Depth (Chorus Depth) 0–127
This specifies the modulation depth of the chorus effect.
Pre Dly (Chorus Pre Delay) 0.0–100 ms
This specifies the delay between when the original sound is
heard and when chorusing begins.
Fbk (Chorus Feedback) 0–127
This specifies the amount of the chorus effect's output to be
returned – fed back – to its input. Higher settings create more
complex chorusing.
Phase 0–180 degree
This specifies the spaciousness of the chorus effect.
Filter Type
This specifies the type of filter to be used by the chorus effect.
OFF: No filter is used.
LPF: Frequencies higher than the selected cutoff frequency
value are eliminated.
HPF: Frequencies lower than the selected cutoff frequency
value are eliminated.
Advertisement
Table of Contents
