Roland XV-3080 Owner's Manual page 55

128 voice 6 x expansion
Hide thumbs Also See for XV-3080:
Table of Contents

Advertisement

the enhancer sound will be output. With a setting of "D0:
100W," only the enhancer sound that is sent through the
flanger will be output.
Level (Output Level)
Adjust the output level.
34: ENHANCER DELAY
This effect connects an enhancer and a delay in series.
fig.2-40
L in
Enhancer
Mix
R in
Enhancer
Mix
Enhancer Sens #
Adjust the sensitivity of the enhancer.
Enhancer Mix (Enhancer Mix Level)
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
DlyTime (Delay Time)
Adjust the time delay from when the direct sound begins
until the delay sound is heard.
Dly Fbk (Delay Feedback Level)
Adjust the proportion (%) of the delay sound that is fed back
into the delay input. Negative (-) settings will invert the
phase.
Delay HF Damp
Adjust the frequency above which delayed sound fed back to
the delay input will be cut. If you do not want to cut the high
frequencies of the delay feedback, set this parameter to
BYPASS.
Delay Balance #
Adjust the volume balance between the enhancer sound that
is sent through the delay and the enhancer sound that is not
sent through the delay. With a setting of "D100: 0W," only
the enhancer sound will be output. With a setting of "D0:
100W," only the enhancer sound that is sent through the
delay will be output.
Level (Output Level)
Adjust the output level.
35: CHORUS DELAY
This effect connects a chorus and a delay unit in series.
L out
Balance D
Balance W
Delay
Balance W
Feedback
R out
Balance D
Chapter 2 Using the XV-3080 Effects
fig.2-41
Balance D
L in
Balance W
Chorus
Balance W
R in
Balance D
Cho Dly (Chorus Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
ChoRate (Chorus Rate)
Adjust the modulation speed of the chorus effect.
Cho Dpt (Chorus Depth)
Adjust the modulation depth of the chorus effect.
Cho Bal (Chorus Balance) #
Adjust the volume balance between the direct sound and the
chorus sound. With a setting of "D100: 0W," only the direct
sound will be output. With a setting of "D0: 100W," only the
chorus sound will be output.
DlyTime (Delay Time)
Adjust the time delay from when the direct sound begins
until the delay sound is heard.
Dly Fbk (Delay Feedback Level)
Adjust the proportion (%) of the delay sound that is fed back
into the delay input. Negative (-) settings will invert the
phase.
Delay HF Damp
Adjust the frequency above which delayed sound fed back to
the delay input will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Delay Balance #
Adjust the volume balance between the chorus sound that is
sent through the delay and the chorus sound that is not sent
through the delay. With a setting of "D100: 0W," only the
chorus sound will be output. With a setting of "D0: 100W,"
only the chorus sound that is sent through the delay will be
output.
Level (Output Level)
Adjust the output level.
L out
Balance D
Balance W
Delay
Balance W
Feedback
R out
Balance D
55

Advertisement

Table of Contents
loading

Table of Contents