Roland XV-3080 Owner's Manual page 88

Chapter 4 Creating a Patch
STRUCT (Structure)
Each of the above two parameters determines how Tone 1
and 2, and Tone 3 and 4 are connected.
Type (Structure type)1–10
fig.4-11
TYPE 1
TONE 1 (3) WG
TONE 2 (4) WG
fig.4-11a
TYPE 2
TONE 1 (3) WG
TVA
TONE 2 (4) WG
fig.4-11b
TYPE 3
TONE 1 (3) WG
TVA
TONE 2 (4) WG
fig.4-11c
TYPE 4
TONE 1 (3) WG TVA
TONE 2 (4) WG
fig.4-11d
TYPE 5
TONE 1 (3) WG
TVA
TONE 2 (4) WG
fig.4-11e
TYPE 6
TONE 1 (3) WG
TVA
TONE 2 (4) WG
88
TVF TVA
TVF TVA
TVF
TVF TVA
TVF
B
TVF TVA
TVF
B
TVF TVA
TVF
R
TVF TVA
TVF
R
TVF TVA
fig.4-11f
TYPE 7
TONE 1 (3) WG
TVF
TONE 2 (4) WG
fig.4-11g
TYPE 8
TONE 1 (3) WG TVF
TONE 2 (4) WG
fig.4-11h
TYPE 9
TONE 1 (3) WG
TVF
TONE 2 (4) WG
TVF
fig.4-11i
TYPE 10
TONE 1 (3) WG
TVF
TONE 2 (4) WG TVF
The display will graphically show the selected Structure. The
displayed symbols have the following meanings.
W1 (WG1), W2 (WG2), F1 (TVF1), F2 (TVF2), A1 (TVA1), A2
(TVA2), B (booster), R (ring modulator)
* If you select a Tone while on the STRUCT page, the Tone
paired with the selected Tone will also be selected.
* If Type 2–10 is selected, turning off one Tone will cause the
other Tone to be connected in the simple order of WG/TVF/
TVA.
Booster (Booster gain)0/+6/+12/+18
The Booster amplifies the incoming signal, causing it to
distort. This creates an effect similar to the distortion often
used on an electric guitar. If the "Type" parameter has been
set to 3 or 4, you can set the Booster strength.
TVA
R
TVF TVA
TVA
R
TVF TVA
TVA
R
TVA
TVA
R
TVA