Roland XV-3080 Owner's Manual page 45

flanger sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
flanger sound will be output.
Level (Output Level)
Adjust the output level.
16: STEP FLANGER
The Step Flanger effect is a flanger in which the flanger pitch
changes in steps. The speed at which the pitch changes can
also be specified in terms of a note-value of a specified
tempo.
fig.2-19
Balance D
L in
Step Flanger
Feedback
Feedback
Step Flanger
R in
Balance D
Pre Dly (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
Rate
Adjust the rate of modulation.
Depth
Adjust the depth of modulation.
Fbk (Feedback Level) #
Adjust the amount (%) of the flanger sound that is returned
(fed back) into the input. Negative (-) settings will invert the
phase.
Phase
Adjust the spatial spread of the sound.
Step Rate #
Adjust the rate (period) of pitch change. This parameter can
be set as a note-value of a specified tempo. In this case,
specify the value of the desired note.
When Step Rate is Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo or the tempo clock of the XV-3080's system.
LowGain
Adjust the gain of the low frequency range.
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Chapter 2 Using the XV-3080 Effects
Hi Gain
Adjust the gain of the high frequency range.
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
flanger sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
chorus sound will be output.
Level (Output Level)
Adjust the output level.
45