Table of Contents
Advertisement
Type
Block
ALL
PR-A, B
PERFORM
USER *2
PR-A, B *3
CARD
PATCH
USER *2
PR-A–F *3
CARD
XP-A–F
RHYTHM
USER *2
PR-A–F*3
CARD
XP-A–F
SYSTEM
CARD
F-LIST
CARD
*1 Since there are no others, Performances other than PR-A/B
cannot be selected.
*2 Move data within the User Memory in block units. The Move
destination Patch is overwritten.
*3 PR-H uses GM data, and cannot be transmitted.
*4 Depends on the Wave Expansion Board installed
*5 After designating the file, set the range specifications for the
block being transmitted.
*6 Specify the file.
* If the number sent exceeds the capacity of the User memory,
then transmission of the data stops the moment the memory is
filled.
Type (Data Type)
This specifies the type of data to be transmitted.
ALL
:Performance, Patch, and Rhythm Set
PERFORM
:Performance
PATCH
:Patch
RHYTHM
:Rhythm Set
SYSTEM
:System
:Favorite List
F-LIST
Block (Source Block)
This specifies the source of the data to be transmitted.
USER:Data from USER memory will be transmitted.
PR-A–F:Preset A–F data will be transmitted.
XP-A–F: Data from a Wave Expansion Board will be
transmitted.
*1
01–64
01–32
01–64
*6
001–128
001–128
001–128
*5
*4
1–4
1–2
1–4
*5
*4
*6
*6
Chapter 7 Saving a Sound You Create
*
XP-A–F can be selected only if the corresponding Wave
Expansion Board is installed.
CARD: Performance/Patch/Rhythm Set/Favorite List/
System data stored on a memory card will be
transmitted.
fig.7-26.e
Destination
This sets the transmission destination to USER.
If the Type parameter has been set to PERFORM, PATCH, or
RHYTHM, you must specify the first memory location
number of the transmission destination.
1. Press [UTILITY] to make its indicator light.
2. Press [
] / [
] to select the UTIL 1 page.
3. Press [
] / [
] to make "XFER" blink.
4. Press [ENTER].
5. Press [
] / [
] to select the TRANSFER TO MIDI
page.
6. Press [
] / [
] to move the cursor to the next
desired parameter.
7. Turn the VALUE dial or by press [INC]/[DEC], select the
desired value.
8. Press [ENTER] to execute the data transmission.
* To interrupt the transmission of data, press [EXIT].
9. Press [EXIT] to return to the previous page.
File number
File name
129
Advertisement
Table of Contents
