Roland XV-3080 Owner's Manual page 38

128 voice 6 x expansion
Hide thumbs Also See for XV-3080:
Table of Contents

Advertisement

Chapter 2 Using the XV-3080 Effects
1: STEREO-EQ (Stereo Equalizer)
This is a four-band stereo equalizer (low, mid x 2, high).
fig.2-04
L in
4-Band EQ
R in
4-Band EQ
LowFreq (Low Frequency)
Select the frequency of the low range (200 Hz/400 Hz).
LowGain (Low Gain)
Adjust the gain of the low frequency.
Hi Freq (High Frequency)
Select the frequency of the high range (4000 Hz/8000 Hz).
Hi Gain (High Gain)
Adjust the gain of the high frequency.
Mid1 Freq (Middle 1 Frequency)
Adjust the frequency of Middle 1 (mid range).
Mid1 Q (Middle 1 Q)
This parameter adjusts the width of the area around the
Middle 1 Frequency that will be affected by the Gain setting.
Higher values of Q will result in a narrower area being
affected.
Mid1 Gain (Middle1 Gain)
Adjust the gain for the area specified by the Middle 1
Frequency and Q settings.
Mid2 Freq (Middle 2 Frequency)
Adjust the frequency of Middle 2 (mid range).
Mid2 Q (Middle 2 Q)
This parameter adjusts the width of the area around the
Middle 2 Frequency that will be affected by the Gain setting.
Higher values of Q will result in a narrower area being
affected.
Mid2 Gain (Middle 2 Gain)
Adjust the gain for the area specified by the Middle 2
Frequency and Q settings.
Level (Output Level) #
Adjust the output level.
38
L out
R out
2: OVERDRIVE
This effect creates a soft distortion similar to that produced
by vacuum tube amplifiers.
fig.2-05
L in
Over
Amp
drive
Simulator
R in
Drive #
Adjust the degree of distortion. The volume will change
together with the degree of distortion.
Level (Output Level)
Adjust the output level.
LowGain (Low Gain)
Adjust the gain of the low frequency range.
Hi Gain (High Gain)
Adjust the gain of the high frequency range.
Amp Type (Amp Simulator Type)
Select the type of guitar amp.
SMALL:small amp
BUILT-IN:single-unit type amp
2-STACK:large double stack amp
3-STACK:large triple stack amp
Pan (Output Pan) #
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
L out
Pan L
2-Band
EQ
Pan R
R out

Advertisement

Table of Contents
loading

Table of Contents