Control Change - Roland XV-3080 Owner's Manual

eeH Data: the actual data to be sent. Multiple bytes of data are transmitted in order
starting from the address.
: :
ffH Data
sum Checksum
F7H EOX (End Of Exclusive)
* The amount of data that can be transmitted at one time depends on the type of data, and
data will be transmitted from the specified starting address and size. Refer to the
Address and Size given in Section 3, "Parameter address map.
* Data larger than 256 bytes will be divided into packets of 256 bytes or less, and each
packet will be sent at an interval of about 20 ms.
* Not received when the Receive Exclusive parameter (SYSTEM/COMMON) is OFF.
Status Data byte
F0H 41H, dev, 42H, 12H, aaH, bbH, ccH,
ddH, ... eeH, sum
Byte Explanation
F0H Exclusive status
41H ID number (Roland)
dev Device ID (dev: 10H)
42H Model ID (GS)
12H Command ID (DT1)
aaH Address MSB: upper byte of the starting address of the transmitted data
bbH Address: middle byte of the starting address of the transmitted data
ccH Address LSB: lower byte of the starting address of the transmitted data
ddH Data: the actual data to be transmitted. Multiple bytes of data are transmitted starting
from the address.
: :
eeH Data
sum Checksum
F7H EOX (End Of Exclusive)
* The amount of data that can be transmitted at one time depends on the type of data, and
data will be transmitted from the specified starting address and size. Refer to the
Address and Size given in Section 3, "Parameter address map.
* Data larger than 256 bytes will be divided into packets of 256 bytes or less, and each
packet will be sent at an interval of about 20 ms.
* Regarding the checksum, please refer to (p.$$$)
* Not received when the Receive Exclusive parameter (SYSTEM/COMMON) is OFF.
2. Data transmission
Channel Voice Messages
When execute the GM Data Transfer, the following Program Change and Control Change
will transmit.

Control Change

Bank Select (Controller number 0, 32)
Status
BnH
BnH
n = MIDI channel number:
mm, ll= Bank nunber: 00 00H - 7F 7FH (bank.1 - bank.16384)
Status
Portamento Time (Controller number 5)
F7H
Status
BnH
n = MIDI channel number:
vv = Portamento Time: 00H - 7FH (0 - 127)
Data Entry (Controller number 6, 38)
Status
BnH
BnH
n = MIDI channel number: 0H - FH (Ch.1 - 16)
mm, ll = the value of the parameter specified by RPN/NRPN
mm = MSB, ll = LSB
Volume (Controller number 7)
Status
BnH
n = MIDI channel number:
vv = Volume: 00H - 7FH (0 - 127)
Panpot (Controller number 10)
Status
BnH
n = MIDI channel number:
vv = Panpot: 00H - 40H - 7FH (Left - Center - Right),
Initial value = 40H (Center)
Portamento (Controller number 65)
Status
BnH
n = MIDI channel number:
vv = Control value:
Resonance (Controller number 71)
Status
BnH
n = MIDI channel number:
vv= Resonance value (relative change): 00H - 7FH (-64 - 0 - +63)
Release Time (Controller number 72)
Status
BnH
n = MIDI channel number:
vv = Release Time value (relative change):
Attack time (Controller number 73)
Status
BnH
n = MIDI channel number:
vv = Attack time value (relative change):
Cutoff (Controller number 74)
Status
BnH
n = MIDI channel number:
vv = Cutoff value (relative change): 00H - 7FH (-64 - 0 - +63)
Decay Time (Controller number 75)
Status
BnH
n = MIDI channel number:
vv = Decay Time value (relative change):
section)
2nd byte 3rd byte
00H mmH
20H llH
0H - FH (Ch.1 - 16)
2nd byte 3rd byte
05H vvH
0H - FH (Ch.1 - 16)
2nd byte 3rd byte
06H mmH
26H llH
2nd byte 3rd byte
07H vvH
0H - FH (Ch.1 - 16)
2nd byte 3rd byte
0AH vvH
0H - FH (Ch.1 - 16)
2nd byte 3rd byte
41H vvH
0H - FH (Ch.1 - 16)
00H - 7FH (0 - 127) 0 - 63 = OFF, 64 - 127 = ON
2nd byte 3rd byte
47H vvH
0H - FH (Ch.1 - 16)
2nd byte 3rd byte
48H vvH
0H - FH (Ch.1 - 16)
00H - 7FH (-64 - 0 - +63)
2nd byte 3rd byte
49H vvH
0H - FH (Ch.1 - 16)
00H - 7FH (-64 - 0 - +63)
2nd byte 3rd byte
4AH vvH
0H - FH (Ch.1 - 16)
2nd byte 3rd byte
4BH vvH
0H - FH (Ch.1 - 16)
00H - 7FH (-64 - 0 - +63)
MIDI Implementation
(sound source
179