Editing Sounds' Attack And Release Time ([Part]-[Part Modify]) - Roland XV-3080 Owner's Manual

* It is not possible for the settings of all Parts to total an amount
greater than 128. The remaining number of available voices
will be displayed to the left of this value (Rest=). Pay attention
to this readout as you make set the Voice Reserve parameter.
Calculating the Number of Voices Being Used
The number of notes that the XV-3080 can sound
simultaneously depends on the number of Tones in the
Patches you are using and the number of keys being
pressed. For example, if you play one note using a Patch
that consists of only one Tone, you will use up one voice
of polyphony. XV-3080 tones may use two Waves, and
when Patches are composed of these tones, this doubles
the two sounds. When two keys are pressed, and the
Patch for each key pressed uses four tones each having
two Waves, a total of sixteen voices is used.
This number is obtained by figuring (the number of
tones with one Wave + the number of tones with two
Waves x 2) x the number of keys pressed.
The XV-3080 is able to play up to 128 Tones
simultaneously. When you are using the XV-3080
multitimbrally, keep this in mind, and adjust your Voice
Reserve settings so that each Part is guaranteed at least
the minimum number of voices it requires.
Editing Sounds' Attack and
Release Time ([PART]-[PART
MODIFY])
You can determine how a Part will pay a sound by setting it
to modify the sound's programmed cutoff frequency,
Resonance, Velocity Sense, and TVF and TVA Envelope
attack and release time settings.
PART MODIFY
Cut (Part cutoff offset)-63–0–+63
This raises or lowers the TVF cutoff frequency settings for
each of the Tones in the Part's sound.
Res (Part resonance offset)-63–0–+63
This raises or lowers the TVF Resonance settings for each of
the Tones in the Part's sound.
Atk (Part attack time offset)
This raises or lowers the TVF/TVA attack time (T1) settings
for each of the Tones in the Part's sound.
* Patches also contain an Atk time offset setting. The final TVF/
TVA Envelope attack time value is therefore the sum of the
Chapter 5 Creating a Performance
Tone's TVF/TVA ENVELOPE T1 setting, the Patch's Atk
time offset, and the Part's Atk time offset. If the Patch's Atk
time offset is already set to 127, there will be no change
produced by setting the Part's Atk time offset to a positive
value.
Rel (Part release time offset)
This raises or lowers the TVF/TVA release time (T4) settings
for each of the Tones in the Part's sound.
* Patches also contain a Rel time offset setting. The final TVF/
TVA Envelope release time value is therefore the sum of the
Tone's TVF/TVA ENVELOPE T4 setting, the Patch's Rel
time offset, and the Part's Rel time offset. If the Patch's Rel
time offset is already set to 127, there will be no change
produced by setting the Part's Rel time offset to a positive
value.
Velocity Sens (Part velocity sensitivity offset)
This raises or lowers the VELOCITY V-Cutoff and the TVA
V-Sens settings for each of the Tones in the Part's sound.
* Patches also contain a Velocity Sens offset setting.
A Tone's ultimate TVF V-Cutoff and TVA V-Sens values are
therefore the sum of the Tone's TVF V-Cutoff and TVA V-
Sens settings, the Patch's Velocity Sens offset and the Part's
Velocity Sens offset . If the Patch's Velocity Sens offset is
already set to 127, there will be no change produced by
setting the Part's Velocity Sens Offset to a positive value.
105