Table of Contents
Advertisement
set, an open hi-hat and a closed hi-hat sound will never occur
simultaneously, since they're produced by the same
instrument – the hi-hat is either open or closed, but not both
at the same time. To simulate this behavior on the XV-3080,
you can set the open and closed hi-hat Rhythm Tones to the
same Mute Group, thus preventing them from being heard at
the same time. If, for example, the open hi-hat Rhythm Tone
is playing and the closed hi-hat's key is struck, the closed hi-
hat Rhythm Tone will turn off the open hi-hat before
sounding.
You can have up to 31 Mute Groups per Rhythm Set. If you
do not want a Rhythm Tone to use a Mute Group, turn the
feature off.
Assign Type MULTI/SINGLE
This setting determines whether a Rhythm Tone note that is
playing is stopped when the same note is played again
(SINGLE), or whether it will continue to play, layered with
the new note.
Rx MIDI (Receive MIDI)
These parameters determine how each Rhythm Tone in a
Rhythm Set will respond to received Expression/Pan/Hold
1 MIDI messages.
Expression (Tone receive expression) OFF/ON
If you want the Rhythm Tone to respond to Expression
messages, turn this parameter on. If not, turn it off.
Pan (Tone receive pan mode)
CONT:Pan messages will be responded to immediately,
instantly changing the stereo position of the Rhythm Tone.
KEY-ON:The stereo location of the Rhythm Tone will be
changed only when the next note is played. If a Pan message
is received while a note is sounding, its stereo location will
not change.
Hold-1 (Tone receive hold 1) OFF/ON
If you want the Tone to respond to Hold 1 messages, turn
this parameter on. If not, turn it off.
Effects Settings (EFFECTS)
Refer to "Adjusting Effect Settings in Rhythm Set mode" (p.
31).
Saving Patches You Create
Refer to "Saving a Rhythm Set" (p. 122).
Chapter 6. Creating a Rhythm Set
Copying the Settings of
Another Rhythm Tone
(Rhythm Key Copy)
Rhythm Tone settings from any Rhythm Set can be copied to
any key of the currently selected Rhythm Set. This function
can save time and effort when creating a Rhythm Set.
1. Make sure that a Rhythm Tone(destination) is selected.
2. Press [UTILITY] to make its indicator light.
3. Press [u] / [d] to select the UTIL 1 page.
4. Use [l] / [r] to make "COPY" blink, and then press
[ENTER].
The RHYTHM KEY CPY page will appear.
fig.6-11.e
Copy source Rhythm Set
(group, number)
Copy source Key
5. Press [l] / [r] to move the cursor to the parameter that
you wish to set.
6. Turn the VALUE dial or press [INC] / [DEC] to select the
desired value.
You can also select the desired key setting by pressing [E]–
[H].
[E]: This selects the key one octave below the currently
selected key.
[F]: This selects the key a semitone below the currently
selected key.
[G]: This selects the key a semitone above the currently
selected key.
[H]: This selects the key one octave above the currently
selected key.
* If a MIDI keyboard is connected, you can select a Rhythm Set
key by pressing the corresponding key on the MIDI keyboard.
7. Press [ENTER] to execute the Copy – an asterisk ("*") is
placed before the destination Rhythm Tone in the
display.
fig.6-12
8. Press [EXIT] to return to the RHYTHM PLAY page.
* To specify the currently selected Patch as the copy source, set
Source to TEMP.
Copy source Rhythm Set
name
Copy destination Key
119
Advertisement
Table of Contents
