Figure 17 Modified Ac Power O-Ring Pigtail Cable - Alcatel-Lucent 9558HC User Manual

9500 family overview
Optical interface
66
Preparing the O-Ring Cable
Modify the pigtail O-ring cable by cutting off the output terminals (the O-ring lug connectors)
on the O-ring cable and splicing the open-ended wires to interface with the DC power
terminal block on the PIB.
Danger: Ensure that the power supply is disconnected from the AC main power feed before
preparing and cutting the DC wires.
To modify the pigtail O-ring cable:
• Cut off the O-ring lugs (items 1 and 2 on the cable in
Assembly) and strip approximately 0.5 cm of shield from each wire to expose the
conductors. See
Figure 17: Modified AC Power O-Ring Pigtail Cable
0.5 cm
(0.2 in)
Connecting the AC Power Converter to the DC inputs on the PIB
To connect the AC power converter to the DC inputs on the PIB:
• Connect the modified end of the pigtail O-ring cable to the DC inputs on the PIB.
Connect the -VDC (black wire) to the -Batt terminal on the PIB terminal block;
connect the +VDC (red wire) to the +Batt terminal on the PIB terminal block.
• Connect the male 6-pin connector on the AC Power Converter (item 1 in
Converter) to the female 6-pin connector on the pigtail cable (item 3 in
Ring Pigtail Cable
• Plug the AC power converter cord (item 2 in
outlet.
One Optical Ethernet cable connects the MPT-HC V2/9558HC to the Ethernet generic
Device and one coaxial cable connects the MPT-HC V2/9558HC to MPT Power Unit, MPT
Extended Power Unit, or office power.
Modified AC Power O-Ring Pigtail
Assembly).
AC Power O-Ring Pigtail Cable
Cable.
AC Power Converter) into an AC power
23094
AC Power
AC Power O-
MPR-e