Interconnect; Section Introduction; Power Cable Connection - Alcatel-Lucent 9500 MPR User Manual

The information contained in this section is a summary of the infor-
mation on the enclosed CD. "Refer to CD" is used throughout this sec-
tion to refer the reader to the detail information on the CD.

INTERCONNECT

3
3.1

SECTION INTRODUCTION

This section gives the location and describes power and signal connections for the 9500
MPR.
3.2

POWER CABLE CONNECTION

See Figure 3-1 and Figure 3-2
is supplied in the MSS Installation Kit. It is supplied with the connector fitted at one end and
wire at the other. The cable is nominally 5 m (16 ft), and the wires are 4 mm
The red (or blue) wire must be connected to -48 Vdc (live); the black wire to ground/+ve.
To prevent connector damage, always check to ensure corresponding
rack circuit breaker is off before connecting/disconnecting power cable.
Note
for power cable connection. The power cable (PN 3DB18271AA)
Figure 3-1 Power Cable and Connector
WARNING
Possibility of
Damage
to Equipment
2
(AWG 12).
3-1