Figure 124 Tmn Rf Field - Alcatel-Lucent 9558HC User Manual

Navigator area
230
Note: The TMN RF in-band Van ID must be different from the one configured for User
Ethernet TMN in-band.
You need to ensure the consistency of the TMN RF configuration at both ends of the radio
interface, otherwise the TMN RF in-band link will not set up.
• NE IP Parameters field
This IP address is the local IP address. The default IP address is: 10.0.1.2. The subnet
mask is 255.255.255.255(/32) and cannot be changed.
• TMN In-band IP parameters
Enter the IP Address with the relevant subnet mask for TMN In-band management.
The VLAN Id can be changed only with the Provisioning Tool (value between 2 and
4080). Default IP addresses: 192.168.100.1. Default subnet mask: 255.255.255.0(/
24).
In the VLAN ID field enter the VLAN ID used for In-band management (default:
4080).
Caution: Changes to these parameters will cause the connection with the MPR-e to be
dropped.
Depending on the changes to the parameters and the type of generic device, it may be
necessary to change the parameters of the PC/device.
• OSPF Management field
This field includes two areas (Areas and Interfaces) to manage OSPF.
Each OSPF interface is attached to an OSPF Area the OSPF Area Id. For example,
in Figure 123, TMN RF is in OSPF Area: 0.0.0.0.
• How to add an OSPF Area
Figure 124: TMN RF field
MPR-e