How To Use The Sabiki Mode - Furuno NAVpilot-300 Operator's Manual

2. STEERING MODES
2.6.1 How to use the SABIKI
Preparations for the SABIKI
• Check that there is a speed sensor connected to the processing unit. Check that
[Speed Calculation] is set to [Auto].
• In the [Ship's Characteristics] menu, set [Boat Type] to [Outboard] or [In/Outboard] ,
[ EVCS-Outboard] or [EVCS-In/Out] .
1. Reduce the vessel's speed to less than 5 knots.
2. Orient the vessel with the stern in a windward direction, or into the current, then
center the rudder.
3. Push the
4. Select [SABIKI]. The SABIKI
shown below is displayed.
Normalized bow direction
Stern heading marker
The vessel direction (heading) may be adjusted manually during the SABIKI
mode. This is helpful in situations such as wind direction change.
Press the
direction as a reference when adjusting course.
The
bow heading by 10° to port. Similarly, the
to starboard.
When the stern is not facing the wind or current, increase reverse throttle as nec-
essary, to adjust direction. Where this method does not rectify the vessel direc-
tion, see section 2.6.2.
Note: You can also activate SABIKI
ther, if [Key Beep] in the [System Setup] menu is set to [ON], the system release a
short beep in the under the following circumstances:
™
• SABIKI
• Set course is changed from an external device.
2-18
™
™
mode
key to show the turn menu.
, ,
1 1
10
key adjust the bow heading by 1° to port and the
1
mode is activated from an external device.
mode
™
mode is activated and a screen similar to the one
SET SET
85º 85º
STERN DIR STERN DIR
130º 130º
COG COG
or key to adjust the bow heading. Use the bow
10
and
1
™
mode from the GC-001 (see section 5.4). Fur-
Bow heading marker
Set course (Stern heading)
Current stern direction
Normalized stern direction
key adjusts the
10
keys adjust bow heading
10
™