Furuno NAVpilot-300 Operator's Manual page 70

5. GESTURE CONTROLLER GC-001
3. Select [Remote1], [Remote2] or [Remote3] as appropriate.
The device selection window appears.
Remote1:
Remote2:
Remote3:
4. On your GC-001, press
5. When the startup process for the GC-001 is complete, press
menu appears.
6. Select [SYSTEM MENU].
7. Select [PAIRING].
8. Select [YES]. The message "PAIRING..." appears on the GC-001 display.
9. On the NAVpilot-300, select the GC-001 to be paired from the device selection
window, then press
Remote1:
Remote2:
Remote3:
Note: If the GC-001 to be paired is not selected within 20 seconds, the message
"TIME OUT!" appears on the GC-001 and the device selection window closes on
the NAVpilot-300. In this case, repeat the above procedure from step 8.
The NAVpilot-300 system and the GC-001 are connected and
paired when the STBY window (example shown to the right) ap-
pears on the GC-001.
10. Close the menu.
5-12
Wireless RC
GC-001 40F671792BE0
▼ Prev Ent
.
10
Wireless RC
GC-001 40F671792BE0
GC-001 5DF00173D00
▼
Prev Ent
Selection window
to turn the GC-001 on.
The detected GC-001
appears here.
. The GC-001
NP300-RC
STBY
HDG M
112