Furuno NAVpilot-300 Operator's Manual page 26

2. STEERING MODES
While NAV mode is active, the steering mode indication appears at the top-left of
the screen, accompanied by the XTE setting indication. The figure below shows
an overview of the NAV mode screen.
Destination/waypoint
indication (red flag)
Own ship indication
5. To deactivate switch from NAV mode to SBTY mode, press
sounds and the mode is changed. Use the steering wheel (helm) to steer the boat.
Note 1: The course reading on the NAVpilot is not always the same as the waypoint
direction shown on the chart plotter.
Note 2: The above operation is available from the GC-001. See section 5.9.
The Control Unit releases a "beep" sound (requires [Key Beep] in the [System Setup]
menu to be set to [ON]) under the following conditions:
• The mode is changed to AUTO mode from external equipment.
• The set course is changed from external equipment.
Note 3: You can also activate NAV mode from the [TURN] menu. Press
the [TURN] menu, then select [NAV] (
2-6
Steering mode indication
: Precision
: Economy
HDG T HDG T
HDG T HDG T HDG T HDG T
COG COG
).
Heading
Destination/waypoint name
Cross track error or bearing
to destination/waypoint
Data source
Rudder indications
and speed, course or
positon indications
STBY
. An audible alert
to show