Furuno NAVpilot-300 Operator's Manual page 65

Display
GC-001 Message
Priority
Alert level: Caution
18 INPUT VOLTAGE IS TOO LOW.
19 INPUT VOLTAGE IS TOO HIGH.
20 ERROR IN NAV MODE PARAME-
TERS.
CHANGE MODES.
21 COMPASS SETTINGS INCOM-
PLETE.
22 HEADING SOURCE CHANGED.
23 EVC OVERRIDE.
24 ARRIVED AT FINAL WAYPOINT.
25 WAYPOINT WAS UPDATED.
26 FISH HUNTER MODE ACTIVAT-
ED.
27 WATCH ALERT.
28 POSITION SOURCE CHANGED.
29 Speed SOURCE CHANGED.
30 NAV MODE COMPLETE.
SWITCHING MODES.
31 HELM SENSOR ERROR.
32 DEVIATION ALERT.
33 WATCH ALERT.
5. GESTURE CONTROLLER GC-001
Processor unit error code and
message
Error code: 2001
"Input voltage is too low."
Error code: 2002
"Input voltage is too high."
Error code: 2003
"Error in NAV mode parameters.
Change modes."
Error code: 2004
"Compass settings incomplete. Set
compass calibration from menu."
Error code: 2005
"Heading source changed. Compass
settings incomplete. Set compass cali-
bration from menu."
Error code: 2008
"EVC Override."
Error code: 2009
"Arrived at final waypoint."
Error code: 2010
"Waypoint was updated."
Error code: 2011
"Fish Hunter mode activated."
Error code: 2013
"Watch Alert!"
Error code: 2006
"Position source changed."
Error code: 2007
"Speed source changed."
Error code: 2014
"NAV mode complete. Switching
modes."
Error code: 2017
"Helm sensor error."
Error code: 2015
"Deviation alert."
Error code: 2016
"Watch Alert!"
5-7