1.4.3
How to select the data to show in the STBY mode
You can select the data to show in the STBY mode as follows:
1. Short press the STBY key to go to the STBY mode.
2. Press the STBY key again to select a display. For example, select the nav data
display.
3. Long-push the Course control knob. The cursor select a data display, as in the
illustration below.
4. For multi-data display, press
5. Rotate the Course control knob to select the data (or graphic) (Graphic displays:
Depth graph, Temperature graph, Engine speed, Compass rose, Rudder, High-
way, Wind)
6. Push the Course control knob.
MODE
COURSE HEADING
NAV DATA
NAV DATA
MODE
COURSE HEADING
NAV DATA
Cursor
or
NAV DATA
to put the cursor on the data to change.
1. INTRODUCTION
1-11