5. GESTURE CONTROLLER GC-001
5.6
How to Adjust the Settings for Your GC-001
All settings for your GC-001 can be adjusted or changed from the [SYSTEM MENU].
Note 1: The procedures outlined in this section use the phrase "Open the [SYSTEM
MENU]." For how to access the [SYSTEM MENU], see section 5.4.
Note 2: The procedures outlined in this section use the phrase "Close the menu." This
means "Press
5.6.1
How to lock/unlock the keys
You can lock the keys to prevent accidental operation.
To lock or unlock the keys, follow the procedure below.
1. Open the [SYSTEM MENU].
2. Select [KEY LOCK].
3. Select [LOCK] to lock the keys. The message "KEY LOCK" appears on the screen
and all keys, except
4. To unlock the keys, press
5. Close the menu.
Note: The keys are automatically unlocked if an alert is released, or if the power is
turned off.
5.6.2
How to change the buzzer and vibration settings
Your GC-001 can release an audible alert and/or vibrate to inform you of alerts. Both
the audible alert (buzzer) and the vibration can be turned on or off, to suit your require-
ments.
To change the buzzer and vibration settings, follow the procedure below.
1. Open the [SYSTEM MENU].
2. Select [ALARM]. The buzzer and vibration menu appears.
3. Select [BUZZER] or [VIBRATION] as required.
4. Select [ON] or [OFF] as required.
When [BUZZER] is set to [ON], the buzzer sounds for approximately two seconds.
When [VIBRATION] is set to [ON], the unit vibrates for approximately two sec-
onds.
Further, the vibration and buzzer indications at the bottom of the screen change
according to the setting, as shown in the table below.
[BUZZER]
5. Close the menu.
5-8
several times until the main screen is shown."
, are locked.
, then select [UNLOCK].
[ON]
[OFF]
[VIBRATION]
[ON]
[OFF]