When Memory Is Full - Ricoh feeder Troubleshooting Manual

When Memory is Full

This section explains likely causes of and possible solutions for problems related
to full memory.
Message
Memory is full.
nn originals have
been scanned.
Press [Print] to
copy scanned
originals. Do not
remove remaining
originals.
"n" in the message repre-
sents a changeable num-
ber.
Press [Continue]
to scan and copy
remaining origi-
nals.
❖ Connect Copy
Message
Sub-machine memo-
ry is full. Sub-
machine will be
disconnected.
Note
❒ If you set [Memory Full Auto Scan Restart] in User Tools to [On], even if the mem-
ory becomes full, the memory overflow message will not be displayed. The
machine will make copies of the scanned originals first, then automatically
proceed scanning and copying the remaining originals. In this case, the result-
ing sorted pages will not be sequential. See "Input / Output", General Set-
tings Guide.
Cause
The scanned originals ex-
ceeds the number of pag-
es that can be stored in
memory.
The machine checked if
the remaining originals
should be copied, after
the scanned originals was
printed.
Cause
The quantity of data ex-
ceeds the capacity of the
sub-machine.
When You Cannot Make Copies As Wanted
Solution
Press [Print] to copy scanned originals
and cancel the scanning data. Press
[Stop] to cancel the scanning data and
not copy.
To continue copying, remove all copies,
and then press [Resume Printing]. To
stop copying, press [Stop].
Solution
Continue printing on the main ma-
chine.
2
33