Ricoh feeder Troubleshooting Manual page 49

Problem
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Data-in lamp does not
blink or light up.
The status indicator of
the printer is lit.
"
Updating the desti-
nation list...
Please wait. Speci-
fied destination(s)
or sender's name has
" appears.
been cleared.
[List / Test Print] is dis-
abled.
Printing does not start
when using the extended
wireless LAN in Ad-hoc
mode.
If the printing does not start, consult your service representative.
Cause
If the machine is operat-
ing in an extended wire-
less LAN, the receiver's
MAC address may be
preventing communica-
tion with the access point.
The extended wireless
LAN has not started.
The login user name, log-
in password, or driver
encryption key is invalid.
Advanced encryption has
been set using the Ex-
tended Security function.
If the data-in lamp is unlit
or not flashing even after
performing [Print], the
machine has not received
the data.
The cause is displayed on
the display of the control
panel.
The destination list is be-
ing updated from the
network using SmartDe-
viceMonitor for Admin.
A mechanical error might
have occurred.
The correct Communica-
tion mode is not set.
When You Cannot Print
Solution
Check access point settings when in the
infrastructure mode. Depending on the
access point, client access may be limit-
ed by MAC address. Also, check there
are no problems in transmission be-
tween access point and wired clients,
and between access point and wireless
clients.
Confirm the orange LED is lit, and the
green LED is lit or blinks during trans-
mission.
Check the login user name, login pass-
word, or driver encryption key.
Check the settings of the Extended Se-
curity function with the administrator.
• When the machine is connected to a
computer via a cable, check the
computer print port settings are cor-
rect. See "Confirming the Connec-
tion Method", Printer Reference.
• When it is networked with a com-
puter, Contact the administrator.
Check the error message on the display
panel and take required action. See p.39
"When a Message Appears".
Wait until the message disappears. Do
not switch off the power while this mes-
sage is displayed. Depending on the
number of destinations to be updated,
there may be some delay before you can
resume operation. Operations are not
possible while this message is displayed.
Contact your service representative.
See "List/Test Print", General Settings
Guide.
Turn the main power off and back on.
See "Turning On/Off the Power",
About This Machine.
Or, change the settings for [System Set-
tings], [Interface Settings], and [Network].
See "Network Settings", General Set-
tings Guide.
3
43