Using Netware - Ricoh 220-240 V Software Manual

Using NetWare

This section describes the setting procedure for network printers in the NetWare
environment. In the NetWare environment, you can connect the printer as a
"print server" or "remote printer".
Important
❒ IPv6 cannot be used on this function.
❖ Setting procedure
• When using the printer as a print server
A Installing SmartDeviceMonitor for Admin
B
Setting the network interface board.
C Turning the printer off and then back on.
• When using the printer as a remote printer
A Installing SmartDeviceMonitor for Admin.
B
Setting the network interface board.
C Setting NetWare.
D
Starting the print server.
Note
❒ This procedure assumes an environment is already prepared for normal Net-
Ware running the printing service setting.
❒ The procedure is explained with the following example settings:
• File server's name ...CAREE
• Print server's name ...PSERV
• Printer's name ...R-PRN
• Queue name ...R-QUEUE
❖ Using SmartDeviceMonitor for Admin
To use the printer in a NetWare environment, use SmartDeviceMonitor for
Admin to set the NetWare printing environment.
Note
❒ The NetWare Client provided by Novell is required to set the printing environ-
ment using SmartDeviceMonitor for Admin under the following environments:
• NDS mode in Windows 95/98/Me
• NDS or Bindery mode in Windows 2000/XP, Windows NT 4.0
Reference
For details about installing SmartDeviceMonitor for Admin, see p.201 "In-
stalling SmartDeviceMonitor for Admin".
❖ Printers listed by SmartDeviceMonitor for Admin
SmartDeviceMonitor for Admin lists printers connected to the network. If
you cannot identify the printer you want to configure, print configuration
page, and then check the printer name.
Using NetWare
7
277