Table of Contents
Advertisement
Message
Name registration success. WINS Serv-
er=<WINS server address> NetBIOS
Name=<NetBIOS name>
Name registration success in Broadcast
name=<NetBIOS Name>
Name registration failed. name=<NetBIOS
name>
nbtd start.
nprinter start (Netware)
nwstart start. (NetWare)
Open log file <file name>
phy release file open failed.
Print queue <print queue name> cannot be
serviced by printer 0, <print server name>
Print server <print servername>has no print-
er.
print session full
Printer <printer name> has no queue
pserver start. (NetWare)
Required file server (<file servername>) not found The required file server is not found.
received EAP Failure
restarted.
sap enable, saptype=<SAP type>, sap-
name=<SAP name>
server identity invalid
session IPv4 <community name> not defined. The requested community name is not defined.
session IPv6 <community name> not defined. The requested community name is not defined.
session <community name> already defined.
session_ipx <community name> not defined.
Set context to <NDS contextname>
smbd start. (NETBIOS)
Problem and solutions
Name registration of <NetBIOS Name> to
<WINS server address> was successful.
Name registration by Broadcast name of <Net-
BIOS Name> was successful.
Name registration of <NetBIOSName> failed.
Change to different NetBIOS name.
The nbtd service has started.
(In the remote printer mode) The NetWare ser-
vice has started.
The service for NetWare protocol stack setting
has started.
(In the print server mode)The specified log file
has been opened.
Replacing the network interface board is required.
Contact your sales or service representative.
(In the print server mode) The print queue
cannot be established. Make sure that print
queue exists on the specified file server.
(In the print server mode) The printer is not as-
signed to the print server. Using NWadmin,
assign the printer, and then restart it.
No more print jobs can be accepted.
(In the print server mode)The print queue is not
assigned to the printer. Using NWadmin, assign
the print queue to the printer, and then restart it.
(In the print server mode)The NetWare service
has started.
EAP reception failed.
The lpd service has started.
The SAP function has started.The SAP packet
is issued to advertise the service on the SAP ta-
ble on the NetWare server.
The server ID is disabled. Check the server au-
thentication.
The requested community name is not defined.
The requested community name is not defined.
An NDS context name has been set.
The smbd service has started.
Message List
6
271
Advertisement
Table of Contents
