Table of Contents
Advertisement
Making Printer Settings Using the Control Panel
❖ Security Method
You can enable or disable encryption. You can also specify the security
type when the encryption is enabled.
• Off
• WEP
Hex:10/26,ASCII:5/13 Digits
• WPA
Encryption Method (TKIP, COMP(AES)), Authentication Method
(WPA-PSK, WPA(802.1X))
Note
❒ Default: Off
❒ The WEP key can be entered using a hexadecimal number or an ASCII
character sequence.
❒ The WPA-PSK can be entered using an ASCII character sequence.
❒ When using 64 bit WEP, up to 10 hexadecimal or 5 ASCII characters can
5
be entered. When using 128 bit WEP, up to 26 hexadecimal or 13 ASCII
characters can be entered.
❒ The WEP key can also be set using Web Image Monitor. For details, see
Web Image Monitor Help.
❖ Wireless LAN Signal
You can check the signal strength when using LAN.
❖ Communication Speed
You can select the transmission speed for IEEE 802.11b.
• Auto
• 11Mbps Fixed
• 5.5Mbps Fixed
• 2Mbps Fixed
• 1Mbps Fixed
Note
❒ Default: Auto
❖ Restore Defaults
Reset the wireless LAN to default.
❖ USB Setting
You can make setting for USB Host interface.
This menu appears only when the optional USB Host interface unit is installed.
• Auto
• Full Speed
Note
❒ Default: Auto
188
Advertisement
Table of Contents
