Genie S-65 Operator's Manual page 29

Third Edition • Second Printing
To Drive
1 Press down the foot switch.
2 Increase speed: Slowly move the drive control
handle off center.
Decrease speed: Slowly move the drive control
handle toward center.
Stop: Return the drive control handle to center or
release the foot switch.
Use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Machine travel speed is restricted when the boom
is raised or extended.
Drive Enable
Light on indicates that the
boom has moved just past
either non-steer wheel and
drive function has been
interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Part No. 82407
Engine Idle Select (rpm)
Select engine idle (rpm) using the symbols on the
control panel.
When the foot switch is not pressed, the engine will
idle at the lowest rpm.
· Turtle symbol: Foot switch activated low idle
· Rabbit symbol: Foot switch activated high idle
Generator (if equipped)
To operate the generator, move the generator
toggle switch to the on position. The engine will
continue to run but no drive or platform functions
will operate.
Plug a power tool into the power to platform GFCI
outlet.
To resume machine functions, move the generator
toggle switch to the off position. All functions will
operate.
Genie S-60 & Genie S-65
Operator's Manual
OPERATING INSTRUCTIONS
27