Genie S-65 Operator's Manual page 23

Third Edition • Second Printing
Test the Oscillating Axle
(if equipped)
32 Start the engine from the platform controls.
33 Drive the right steer tire up onto a 6 inch /
15.2 cm block or curb.
Result: The three remaining tires should stay in
firm contact with the ground.
34 Drive the left steer tire up onto a 6 inch /
15.2 cm block or curb.
Result: The three remaining tires should stay in
firm contact with the ground.
35 Drive both steer tires up onto a 6 inch / 15.2 cm
block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Test the Drive Enable System
36 Press down the foot switch and lower the boom
to the stowed position.
37 Rotate the turntable until the boom moves past
one of the non-steer wheels.
Result: The drive
enable indicator light
should come on and
remain on while the
boom is anywhere in
the range shown.
38 Move the drive control handle off center.
Result: The drive function should not operate.
Part No. 82407
39 Move and hold the drive enable toggle switch to
either side and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that the
drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform
controls and the drive
chassis to identify the
direction of travel.
Test Limited Drive Speed
40 Press down the foot switch.
41 Raise the boom to just above horizontal.
42 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the boom raised should not exceed 1 foot /
30 cm per second.
43 Lower the boom to the stowed position.
Genie S-60 & Genie S-65
Operator's Manual
FUNCTION TESTS
Blue
Yellow
21