Genie S-65 Operator's Manual page 24

Operator's Manual
FUNCTION TESTS
44 Extend the boom 1 foot / 30 cm.
45 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the boom extended should not exceed 1
foot / 30 cm per second.
If the drive speed with the boom raised or extended
exceeds 1 foot / 30 cm per second, immediately
tag and remove the machine from service.
Test Auxiliary Controls
46 Shut off the engine.
47 Pull out the red Emergency Stop button to
the on position.
48 Press down the foot switch.
49 Simultaneously hold the auxiliary power switch
on and activate each function control handle or
toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate. Drive functions should not operate with
auxiliary power.
Test the Lift/Drive Select Function
(if equipped)
50 Press down the foot switch.
51 Move the drive control handle off center.
52 Activate each boom function toggle switch.
Result: No boom functions should operate. The
machine will move in the direction indicated on
the control panel.
22 Genie S-60 & Genie S-65
Third Edition • Second Printing
Part No. 82407