Genie S-65 Operator's Manual page 22

Operator's Manual
FUNCTION TESTS
Test the Foot Switch
19 Push in the platform red Emergency Stop button
to the off position.
20 Pull out the red Emergency Stop button to
the on position but do not start the engine.
21 Press down the foot switch and attempt to start
the engine by moving the start toggle switch to
either side.
Result: The engine should not start.
22 Do not press down the foot switch and restart
the engine.
23 Do not press down the foot switch. Test each
machine function.
Result: The machine functions should not
operate.
Test Machine Functions
24 Press down the foot switch.
25 Activate each machine function control handle
or toggle switch.
Result: All boom/platform functions should
operate through a full cycle.
Machines equipped with Platform Level Control
Disable Function: The platform level toggle switch
will not operate when the boom is raised or
extended past the drive speed limit switches.
20
Test the Steering
26 Press down the foot switch.
27 Press the thumb rocker switch on top of the
drive control handle in the direction indicated by
the blue triangle on the control panel OR slowly
move the drive/steer control handle in the
direction indicated by the blue triangle.
Result: The steer wheels should turn in the
direction that the blue triangles point on the
drive chassis.
28 Press the thumb rocker switch in the direction
indicated by the yellow triangle on the control
panel OR slowly move the drive/steer handle in
the direction indicated by the yellow triangle.
Result: The steer wheels should turn in the
direction that the yellow triangles point on the
drive chassis.
Test Drive and Braking
29 Press down the foot switch.
30 Slowly move the drive control handle in the
direction indicated by the blue arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the drive
chassis, then come to an abrupt stop.
31 Slowly move the drive control handle in the
direction indicated by the yellow arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
drive chassis, then come to an abrupt stop.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.
Genie S-60 & Genie S-65
Third Edition • Second Printing
Part No. 82407