Ricoh Priport JP5000 Operating Instructions Manual page 128

OPTIONAL FUNCTIONS
To change the value entered,
press the {Clear/Stop} key and
enter the new value.
J
After you have finished designat-
ing modes for all the command
sheets, select [Outside Area] with
the [ ], [ ], { { { { ~ ~ ~ ~ } } } } , or { { { { } } } } } } } } key.
2
Then press the [OK] key.
K
Select the mode for the outside
area with the [ ], [ ], { { { { ~ ~ ~ ~ } } } } , or
{ { { { } } } } } } } } key.
L
Press the [OK] key.
Note
When you select Photo mode
for both inside and outside ar-
eas, you cannot select different
coarseness and image density.
When you want to confirm your
settings, press the {Make-Up}
key twice. Then press the [OK]
key repeatedly until the panel
display reaches the setting you
want to confirm.
M
If you have selected Photo mode,
select the coarseness and the im-
106
age density with the [ ], [ ],
{~}, or { { { { } } } } } } } } key.
Note
Four coarseness settings are
available:
• Setting 4: coarsest
• Setting 3: coarser than setting
TPES530E
2
• Setting 2: coarser than setting
1
• Setting 1: coarser than the
standard setting
N
Press the [OK] key.
O
Set the first command sheet face
down on the exposure glass (con-
tact glass) and press the { { { { Start} } } }
TPES530E key.
Program
Clear/Stop
The beeper sounds after the com-
mand sheet is scanned.
Note
Repeat step O for the other com-
mand sheets.
P
Set the original face down on the
exposure glass (contact glass) and
press the { { { { Start} } } } key.
TPES530E
Clear Modes
Auto Cycle
Proof
Print
Enter
Start
TPES050N