Test The Tilt Sensor - Genie S-80 Service Manual

Service Manual - First Edition
3 Turn the key switch to platform control.
4 At the platform controls, pull out the Emergency
Stop button to the
ON
the foot switch.
5 Simultaneously hold the auxiliary power switch
on while activating the following functions
through a partial cycle:
· jib boom up/down (S-85 models)
· boom up/down
· extend and retract
· turntable rotate right/left
· steer right/left
Result: Each function should operate smoothly.
Auxiliary power will not lift the
boom past the drive limit switch
unless the axles are fully
extended.
Part No. 34032
position, then press down
Genie S-80 & Genie S-85
Section 4 - Scheduled Maintenance Procedures
TABLE A PROCEDURES
A-13

Test the Tilt Sensor

The tilt sensor sounds an alarm in the platform
when the incline of the turntable exceeds
4.5 degrees.
Select a level test area. The tilt
alarm should not be sounding
prior to test.
1 Start the engine from the platform controls.
2 Open the tank side cover and press down on
one side of the tilt sensor.
Result: After a 1.5 second delay, the alarm in
the platform should sound.
a
a fuel tank
b tilt sensor
c ground control box
c
b
4 - 7