Agilent Technologies E8362B Service Manual page 307

PNA Series Microwave Network Analyzers
E8362B, E8363B, E8364B
Figure 7-31 Hard Disk Drive Assembly (Exploded View)
Replacement Procedure
Installing the New A41 Hard Disk Drive
Refer to Figure 7-31.
1. With the disk drive bracket right-side up (it is shown upside down in
insert four bushings (item
2. Connect the new hard disk drive (item
firmly into the connector on the interface board. Take special care to align the
connector pins. Applying power to a misaligned connection can permanently
damage the hard disk drive.
3. While holding the disk drive in place, turn the bracket over and insert the other four
②
bushings (item
Service Guide E8364-90026
②
) into the four holes in the bracket.
), into the other side of the same four holes specified in step 1.
Removing and Replacing the A41 Hard Disk Drive
④
) to the interface board (item
Repair and Replacement Procedures
Figure 7-31),
③
) by pushing it
7- 65