Agilent Technologies E8362B Service Manual page 29

PNA Series Microwave Network Analyzers
E8362B, E8363B, E8364B
a
Equipment
Extender board
T-8 TORX driver
T-10 TORX driver
T-20 TORX driver
1/4-inch and 5/16-inch
open-end wrench
5/16-inch, open-end
torque wrench
1-inch, open-end torque
wrench
20-mm, open-end torque
wrench
Adjustable antistatic
wrist strap
Antistatic wrist strap
grounding cord (5 foot)
Static control table mat
and earth ground wire
Floppy disks
a. Unless specified otherwise, equipment listed is required for all analyzer models.
b. P = Performance tests, A = Adjustments, T = Troubleshooting, R = Repair, V = System verification
Service Guide E8364-90026
Critical Specifications
Tools
N/A
0.6 N-m (5 in-lb) setting
0.5, 0.8, and 1.0 N-m
(4, 7, and 9 in-lb) settings
2.4 N-m (21 in-lb) setting
Thin profile
1.1 and 2.4 N-m
(10 and 21 in-lb) settings
(for semi-rigid cables)
8.1 N-m (72 in-lb) setting
(for Port 1 and Port 2
connector nuts)
0.9 N-m (8 in-lb) setting
(for Port 1 and Port 2
measurement connections)
Static Safety Parts
N/A
N/A
N/A
3.5 inch
General Product Information
Required Service Test Equipment
Recommended Alternate
Model or Part Model
Number Number
E8356-60021 None
N/A N/A
N/A N/A
N/A N/A
8710-0510 N/A
N/A N/A
N/A N/A
N/A N/A
9300-1367 None
9300-0980 None
9300-0797 None
Any None
b
Use
T
R
T,R
T,R
A,R
T,R
R
R
P,A,T
P,A,T
P,A,T
A
2- 9