Connecting An F11-F13 Fan (Fan F11 Example) - Enterasys SSA-T1068-0652 Hardware Installation Manual

Replacing the SSA Fans
b. Remove the failed fan's cables from the rubber grommet.
c.
5. Unwind the replacement fan's cables.
6. Remove the cable clip from the replacement fan. See Figure
You may discard the cable clip.
7. With the label side of the replacement fan facing into the second power supply bay (labeled
PS2) and the cable on the left, slip the fan cable into the rubber grommet and connect the cable
to the chassis connector. See Figure
Figure 3-14
1 Fan F11 connector
8. Position the fan in the SSA.
9. Position the cables of the F11–F13 fans on top of the fans, ensuring that the cables are not in a
position that would cause the cables to be pinched by the rear panel.
10. Reinstall the rear panel of the SSA.
You can now reinstall the SSA in the equipment rack.
3-16 Troubleshooting
You may have to lift the rubber grommet out of the chassis to remove the failed fan's
cables from the grommet. The grommet is slit.
Disconnect the fan from the appropriate connector.
The bank of F11–F13 connectors is located next to fan F11, on the other side of the sheet
metal wall that separates the power supply bays from the rest of the SSA. If you are facing
towards the back of the SSA, the F11–F13 connectors are arranged as follows:
‐ F11 connector: left connector
‐ F12 connector: middle connector
‐ F13 connector: right connector
Connecting an F11–F13 Fan (Fan F11 Example)
3‐14.
2 Fan F11
3‐9 on page 3‐12.
3 Rubber grommet