Securing The Ssa To The Rear Of The Rails; Screw To Remove If You Plan To Secure The Left Rear Of The Ssa; Securing The Rear Of The Ssa (Four-Post Rack Example) - Enterasys SSA-T1068-0652 Hardware Installation Manual

The SSA rail kit does not include screws for attaching the mounting brackets to the rack posts.
4. Snap the 10‐32 cage nuts, included in the SSA rail kit, into the square screw holes on the front
mounting ears of the rails.
5. Slide the SSA onto the rails until the front of the SSA is against the mounting ears of the rails.
6. Secure the front of the SSA to the rails by screwing the 10‐32 screws, included in the SSA rail
kit, into the mounting ears on the right and left front of the SSA.
7. (Optional) Secure the rear of the SSA to the rails. See "Securing the SSA to the Rear of the
Rails" on page 2‐11.

Securing the SSA to the Rear of the Rails

The optional procedure of securing the SSA to the rear of the SSA rails applies to all rack
installation scenarios (four‐post rack, 7‐inch two‐post rack, and 3‐inch two‐post rack). Securing
the rear of the SSA is recommended only if you are shipping the rack in which the SSA is installed.
If you plan to secure the left rear corner of the SSA, you must remove the screw from the left rear
corner of the SSA before installing the SSA in the rack. See Figure
Figure 2-7
1 Remove this screw before installing the SSA in the rack
To secure the rear of the SSA to the rails, screw the 2‐56 screws, included in the SSA rail kit, into
the screw tabs on the right and left rail. See Figure
Figure 2-8

Screw to Remove if You Plan to Secure the Left Rear of the SSA

Securing the Rear of the SSA (Four-post Rack Example)

2‐8.
Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide 2-11
Mounting the SSA
2‐7.