Table of Contents
Advertisement
Switch Configuration Using CLI Commands
The CLI commands enable you to perform complete switch configuration management tasks. For
CLI command set information and how to configure the switch, refer to the Enterasys 800-Series
CLI Reference.
Fan Operation on the 800-Series
The 800-Series switches support two unique fan control mechanisms.
1.
The 08G20G2-08, 08G20G4-24, and 08H20G4-48 switches will turn on their fans with the initial
boot-up procedure and will turn off their fans when the room temperature is below 32
°
(89.6
F). If the room temperature rises above 36
turn on again.
2.
The 08G20G2-08P, 08G20G4-24P, 08G20G4-48, 08G20G4-48P, 08H20G4-24P, and 08H20G4-48P
switches will never turn their fans off. Instead their fans will toggle between high and low
revolution speeds. During the initial boot-up procedure and when the room temperature is
°
above 36
C (96.8
temperature falls below 32
revolution speed.
The 08H20G4-24 is the only switch in this series that can operate between 0
°
(122
F) without the need for internal fans.
Standards Compatibility
The Copper ports are compliant with the following standards and operations:
•
IEEE 802.3
•
IEEE 802.3u
•
IEEE 802.3ab
•
IEEE 802.3ad
•
Support Half/Full-Duplex operations
•
Auto-negotiation, Auto MDI/MDIX
•
IEEE 802.3x Flow Control support for Full-Duplex mode, Back Pressure when Half-Duplex
mode, and Head-of-line blocking prevention
•
IEEE 802.3an compliance
The SFP ports are compliant with the following standards and operations:
•
IEEE 802.3z
•
IEEE 802.3x Flow Control support for Full-Duplex mode
•
Auto-negotiation for Full-Duplex control operation
°
F), these fans will operate at a high revolution speed. If the room
°
°
C (89.6
F), then these switches' fans will operate at a low
°
°
C (96.8
F), these switches' internal fans will
°
C (32
Enterasys 800-Series Hardware Installation Guide 1-7
Features
°
C
°
°
F) and 50
C
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
