Attaching The Mounting Brackets To The Rails (Left Rail Example); Positioning And Attaching The Rails To The 7-Inch Posts - Enterasys SSA-T1068-0652 Hardware Installation Manual

Mounting the SSA
2. Attach a mounting bracket, included in the SSA rail kit, to the outside of each rail using the 6‐
32 screws removed in step 1. See Figure
Use four 6‐32 screws to attach each mounting bracket. Leave the 6‐32 screws loose to position
the mounting brackets properly against the rack posts.
Figure 2-4
1 Mounting bracket
3. Position the right and left rails, which are labeled on the inside of each rail, in the rack with the
bottom lip of the rail facing into the rack.
The front mounting ears of the rails should be flush against the front screw holes of the rack
posts. The mounting brackets should be flush against the rear screw holes of the rack posts.
See Figure
Figure 2-5
1 Securing the left rail to the front of the 7-inch
post
2-8 Installation

Attaching the Mounting Brackets to the Rails (Left Rail Example)

2‐5.

Positioning and Attaching the Rails to the 7-inch Posts

2‐4.
2 Rail
2 Securing the left mounting bracket to the rear of
the 7-inch post