Adjusting The Blower Speed (Optional); Continuous/Intermittent Pilot Switch; Power Outages - Lopi Radiant Plus GSB2 Small Installation Manual

Small inbuilt
Hide thumbs Also See for Radiant Plus GSB2 Small:
Table of Contents

Advertisement

34

Adjusting the Blower Speed (Optional)

The optional blower helps transfer heat from the heater into the room. It will not turn on until the heater is
up to temperature (approximately 10 minutes after starting). See the illustration below for instructions on
adjusting the blower speed.
Turn the dial all the
way counter-clockwise
until it clicks off.

Continuous/Intermittent Pilot Switch

This heater may run with the pilot continuously running or in intermittent
mode. For most homeowners, the intermittent mode is preferred (this
saves fuel, doesn't give off un-needed heat). However, in some situations
the homeowner may prefer to switch the heater to continuous pilot. The
most typical reasons for switching to continuous pilot are:
Very Cold Conditions – in very cold conditions you may notice that the burner does not light quickly,
and the flames lift off the burner. If this is situation, we recommend you switch to continuous pilot.
This will create a slight draft in the vent, allowing for the burner to light quickly and draft correctly.
Excessive Condensation on Glass After Startup – certain installations may encounter excessive
fogging on the window after startup (not just the first time the heater was started). This is an
aesthetic condition that may be remedied by switching the heater to continuous pilot.
Cold Glass or Heater Front – in very cold conditions you may notice that the heater front and glass
become very cold. To remedy this, switch the heater to continuous pilot.
Frequent On / Off Operation – if you are frequently turning the heater on and off, you may wish to
leave it in continuous pilot. This allows the burner to turn on more quickly, without pilot ignition delay.

Power Outages

The heater will work if household current (AC power) is disconnected.
© Travis Industries
Operation
OFF
The high position is all the
way counter-clockwise,
without clicking off.
HIGH
5/2/18-1476
LOW
Turn the dial all the
way clockwise.
Radiant Small GSB2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents