Optional Remote - Lopi Radiant Plus GSB2 Small Installation Manual

44 Optional Equipment

Optional Remote

Installation
1 Disconnect the power cord Molex connector
from the Electronic Controls Assembly.
2 GSB2 units require the electronic controls
assembly (IFC) to be removed to allow
access to the wiring and controls. Using an
11/32" wrench to loosen the nut on the left
side that holds the Electronic Controls
Assembly in place (see picture in step 3).
3 Remove the assembly by slightly lifting the right side and slide it to the right. This will disengage the
main connector from the valve. Once the Electronic Controls Assembly is disconnected from the
valve, slide it forward, out of the appliance. The pilot wires will still be connected and are long enough
allow the assembly to be pulled clear of the unit. Make sure not to damage the pilot wires.
Loosen 11/32" Nut.
© Travis Industries
This connection will disengage as the assembly moves
right. The assembly can then be removed as shown below.
5/2/18-1476
(
for qualified installers only)
Lift this side up
slightly and slide
assembly to the
right.
Radiant Small GSB2