Lopi Radiant Plus GSB2 Small Installation Manual page 42

42 Optional Equipment
3. Remove the burner and place it aside.
4. Install the LP (propane) pilot orifice following the instructions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then
replace the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
a
© Travis Industries
(
for qualified installers only)
Natural Gas Orifice = .018N
LP (Propane) Orifce = .014LP
7/16" Wrench
5/2/18-1476
b
.018N
.014LP
Radiant Small GSB2