Table of Contents
Advertisement
Adjusting the Blower Speed
The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to
temperature (approximately 10 minutes after starting). See the illustration below for instructions on
adjusting the blower speed.
OFF
Turn the dial all the
way counter-clockwise
until it clicks off.
Normal Operating Sounds
Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Gas Control Valve
As the gas control valve
is turned on and off you
will hear a dull clicking
sound. This is the valve
opening up and shutting
down.
Normal Operating Odors
This appliance has several areas that reach high temperatures. Dust or other particles on these areas may
burn and create a burnt-paper smell. This is normal during startup. You may notice the smell is more acute
if the appliance was left idle for a long period.
Travis Industries
Operation
HIGH
The high position is all the
way counter-clockwise,
without clicking off.
100-01135
LOW
Turn the dial all the
way clockwise.
Blower
This heater may utilize a blower to push
heated air into the room. You will hear
the sound of air movement that
increases as the speed is increased.
The appliance may creak with
change of temperature.
Blower Snap Disk
This part can produce a clicking sound
as it turns the blower on and off.
Extinction Pops
It is not unusual, especially on Propane (LP) appliances,
to experience a "pop" when the burner is shut off.
23
4 0 4 0 8 0 9
Advertisement
Table of Contents
